工作500小时后的保养-注塑机保养计划

详细内容

Inspection/Maintenance, 500h
工作500小时后的保养
Inspection of the safety devices:
安全装置的检测
Checking of emergency stop buttons
紧急停止开关的检测
Checking of safety gates, mold area
装模部分安全门的检测
Checking of safety gates, nozzle area
喷嘴部分安全门的检测
Checking of safety gates, plasticising area
塑化部分安全门的检测
Checking of safety gates, ejector area
顶出部分安全门的检测
Checking of fixed safety covers
固定安全盖板的检测
Check centering of nozzle:
检测喷嘴中心
0-point at mold change
换模零点
Check oil level
检查液压油位
Hydraulic tubing:
高压软管
Check for service life
检查使用寿命
Check for damage and leakage
检查损坏和漏油
Perform leakage check
运行漏油检查
Hydraulic tubing connections:
高压软管接头检查
Check for damage and leakage
检查损坏和漏油
Perform leakage check
运行漏油检查
Perform leakage check for control blocks
运作中检查阀板的漏油情况
Cleaning the suction filter
清洗吸油过滤器
Exchange of fine filter after alarm
在报警后更换过滤器
Check clamping pressure
检测锁模压力
Check nitrogen-preload/pressure aumulator
检查储能器的充氮情况和压力
Check condition of guides and running wheels
检测导轨和滚珠的状况
Check barrel heating
检查机筒加热
Check nozzle heating
检查喷嘴加热
Check thermocouple seat
检查热电偶座
Cleaning the meter pipes, flow controller
清洗冷却水分配控制器的计量管
Check connections for leaks, flow controller
检查冷却水分配控制器的接头泄漏情况
Cleaning the filter screen, water filter
清洗过滤器的滤芯，水过滤器
check cylinder flange cooling
检查机筒法兰冷却水
check connexions and plugs for correct seat
检查接头和插座的正确位置
Cleaning the filter mats, control cabi cooling
清洗配电箱的冷却滤网
Check the non-return valve
清洗单向阀
Lubrication of the profile rails
U形导轨的润滑
Cleaning the ventilation filter, hydraulic oil tank
清洗空气滤清器的滤芯和液压油箱
Check function and level, lubricator
检查润滑器的功能和油位
Check level, centralized lubrication
检查集中润滑的油位