工作5000小时后的保养-注塑机保养计划(一)

详细内容

Inspection/Maintenance, 5000h
工作5000小时后的保养
Inspection of the safety devices:
安全装置的检测
Checking of emergency stop buttons
紧急停止开关的检测
Checking of safety gates, mold area
装模部分安全门的检测
Checking of safety gates, nozzle area
喷嘴部分安全门的检测
Checking of safety gates, plasticising area
塑化部分安全门的检测
Checking of safety gates, ejector area
顶出部分安全门的检测
Checking of fixed safety covers
固定安全盖板的检测
Check centering of nozzle:
检测喷嘴中心
1- point at mold change
换模零点
Control machine position/leveling
控制机器的位置/水平
Check clamping system/pins/bushing
检测锁模系统/电线接点/衬套
Check tie bar extension
检测拉杆的拉伸
Check platen parallelism
检测模板的平行
Check condition of guides and running wheels
检测导轨和滚珠的状况
Check pressure gauges
检测压力表
Changing the hydraulic oil and cleaning the hydraulic oil tank
更换液压油和清洗液压油箱
Cleaning the oil cooler
清洗油冷却器
Hydraulic tubing:
高压软管
Check for service life
检查使用寿命
Check for damage and leakage
检查损坏和漏油
Perform leakage check
运行漏油检查
Hydraulic tubing connections:
高压软管接头检查
Check for damage and leakage
检查损坏和漏油
Perform leakage check
运行漏油检查
Check tube fixings for correct seat
检查油管连接的正确位置
Perform leakage check for control blocks
运作中检查阀板的漏油情况
Cleaning the suction filter
清洗吸油过滤器
Exchange of fine filter after alarm
在报警后更换过滤器
Check system pressure
检测系统压力
Check charac. curve (hysteresis) prop. pressure valve
检查压力比例阀的特征曲线
Check charac. curve (hysteresis) prop. volume valve
检查流量比例阀的特征曲线 10
Check nitrogen-preload/pressure aumulator
检查储能器的充氮情况和压力
Check barrel heating
检查机筒加热
Check nozzle heating
检查喷嘴加热
Check thermocouple seat
检查热电偶座
Cleaning the meter pipes, flow controller
清洗冷却水分配控制器的计量管
Check connections for leaks, flow controller
检查冷却水分配控制器的接头泄漏情况
Lubrication of the profile rails
U形导轨的润滑
Cleaning the filter screen, water filter
清洗过滤器的滤芯，水过滤器
Check function and level, lubricator
检查润滑器的功能和油位
Check level, centralized lubrication
检查集中润滑的油位
check cylinder flange cooling
检查机筒法兰冷却水
Check the non-return valve
清洗单向阀
Cleaning the ventilation filter, hydraulic oil tank
清洗空气滤清器的滤芯和液压油箱
Check control cabi and conduit boxes for closeness